Before you start
Install your Ozly eSIM before you travel if you can. Installation needs Wi-Fi or a reliable internet connection, and it should not be done over tethered hotspot Wi-Fi.
Installing is different from connecting. Your eSIM can be installed before your trip, then it connects once you arrive in the destination covered by your plan.
Install your eSIM
- Open your Ozly activation email while connected to Wi-Fi.
- Tap Install on Android, or open Settings > Network and Internet > SIMs.
- Tap Add eSIM, then Set up an eSIM.
- Follow the prompts your Pixel displays.
- For code setup, choose Try these troubleshooting steps, then Enter activation code.
- Use the installation code from your Ozly email, then tap Connect or Download.
When you land
- Open Settings > Network and Internet > SIMs.
- Select your Ozly eSIM and make sure it is turned on.
- Turn Data Roaming on for the Ozly eSIM.
- If your Pixel shows a Mobile Data option, set it to your Ozly eSIM.
It can take up to 15 minutes to join a network for the first time. If it does not connect right away, turn flight mode on for 30 seconds, then turn it off again.
A few useful notes
- Follow the prompts your phone displays during setup. The exact wording can vary by device and software version.
- Do not delete the Ozly eSIM after installation. Removing it can permanently remove the profile from that device.
- If your phone says it cannot activate before you travel, that can be normal. The eSIM connects when it reaches the supported destination network.
- To avoid unexpected roaming charges from your home provider, check roaming settings on your primary SIM before you leave.